Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

1082 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

35 Obsolete and Discontinued Commands

:MTESt:AVERage:COUNt

(see page 1138)

Command Syntax

:MTESt:AVERage:COUNt <count>

<count> ::= an integer from 2 to 65536 in NR1 format

The :MTESt:AVERage:COUNt command sets the number of averages for the

waveforms. With the AVERage acquisition type, the :MTESt:AVERage:COUNt

command specifies the number of data values to be averaged for each time

bucket before the acquisition is considered complete for that time bucket.

Query Syntax

:MTESt:AVERage:COUNt?

The :MTESt:AVERage:COUNt? query returns the currently selected count

value.

Return Format

<count> ::= an integer from 2 to 65536 in NR1 format

See Also • "Introduction to :MTESt Commands" on page 491

• ":MTESt:AVERage" on page 1081

NOTE

The :MTESt:AVERage:COUNt command is obsolete and is provided for backward

compatibility to previous oscilloscopes. Use the :ACQuire:COUNt command (see page 230)

instead.

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series