Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

:SBUS<n> Commands 27

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 673

:SBUS<n>:FLEXray:CHANnel

(see page 1138)

Command Syntax

:SBUS<n>:FLEXray:CHANnel <channel>

<channel> ::= {A | B}

The :SBUS<n>:FLEXray:CHANnel command specifies the bus channel, A or

B, of the FlexRay signal.

Query Syntax

:SBUS<n>:FLEXray:CHANnel?

The :SBUS<n>:FLEXray:CHANnel? query returns the current bus channel

setting.

Return Format

<channel> ::= {A | B}

See Also • "Introduction to :TRIGger Commands" on page 877

• ":SBUS<n>:FLEXray Commands" on page 669

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series