Agilent Technologies InfiniiVision 3000 X-Series

:TRIGger Commands 31
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 895
:TRIGger:DELay:TRIGger:SOURce
(see page 1138)
Command Syntax
:TRIGger:DELay:TRIGger:SOURce <source>
<source> ::= {CHANnel<n> | DIGital<d>}
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :TRIGger:DELay:TRIGger:SOURce command selects the input used for
the trigger edge in the Edge Then Edge trigger.
Query Syntax
:TRIGger:DELay:TRIGger:SOURce?
The :TRIGger:DELay:TRIGger:SOURce? query returns the current trigger
edge source.
Return Format
<source><NL>
<source> ::= {CHAN<n> | DIG<d>}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:DELay:TRIGger:SLOPe" on page 894
• ":TRIGger:DELay:TDELay:TIME" on page 892
• ":TRIGger:DELay:TRIGger:COUNt" on page 893
• ":TRIGger:MODE" on page 886