Agilent Technologies InfiniiVision 3000 X-Series - Save:filename

:SAVE Commands 26
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 609
:SAVE:FILename
(see page 1138)
Command Syntax
:SAVE:FILename <base_name>
<base_name> ::= quoted ASCII string
The :SAVE:FILename command specifies the source for any SAVE
operations.
Query Syntax
:SAVE:FILename?
The :SAVE:FILename? query returns the current SAVE filename.
Return Format
<base_name><NL>
<base_name> ::= quoted ASCII string
See Also • "Introduction to :SAVE Commands" on page 607
• ":SAVE:IMAGe[:STARt]" on page 610
• ":SAVE:SETup[:STARt]" on page 620
• ":SAVE:WAVeform[:STARt]" on page 621
• ":SAVE:PWD" on page 619
• ":RECall:FILename" on page 600
NOTE
This command specifies a file's base name only, without path information or an extension.