Agilent Technologies InfiniiVision 3000 X-Series

:SEARch Commands 28
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 819
:SEARch:SERial:FLEXray:MODE
(see page 1138)
Command Syntax
:SEARch:SERial:FLEXray:MODE <value>
<value> := {FRAMe | CYCLe | DATA | HERRor | FERRor | AERRor}
The :SEARch:SERial:FLEXray:MODE command selects the type of FlexRay
information to find in the Lister display:
• FRAMe — searches for FlexRay frames with the specified frame ID.
• CYCLe — searches for FlexRay frames with the specified cycle number
and frame ID.
• DATA — searches for FlexRay frames with the specified data, cycle
number, and frame ID.
• HERRor — searches for header CRC errors.
• FERRor — searches for frame CRC errors.
• AERRor — searches for all errors.
Query Syntax
:SEARch:SERial:FLEXray:MODE?
The :SEARch:SERial:FLEXray:MODE? query returns the currently selected
mode.
Return Format
<value><NL>
<value> := {FRAM | CYCL | DATA | HERR | FERR | AERR}
See Also • Chapter 28, “:SEARch Commands,” starting on page 777
• ":SEARch:SERial:FLEXray:FRAMe" on page 818
• ":SEARch:SERial:FLEXray:CYCLe" on page 815
• ":SEARch:SERial:FLEXray:DATA" on page 816