Agilent Technologies InfiniiVision 3000 X-Series - Whats New in Version 1.10

What's New 1
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 43
What's New in Version 1.10
New command descriptions for Version 1.10 of the InfiniiVision
3000 X-Series oscilloscope software appear below.
New Commands
Command Description
:SYSTem:PRESet (see page 858) Now documented, this command is equivalent
to the front panel [Default Setup] key which
leaves some user settings, like preferences,
unchanged. The *RST command is equivalent
to a factory default setup where no user
settings are left unchanged.