Agilent Technologies InfiniiVision 3000 X-Series

956 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
31 :TRIGger Commands
:TRIGger:USB:SPEed
(see page 1138)
Command Syntax
:TRIGger:USB:SPEed <value>
<value> ::= {LOW | FULL}
The :TRIGger:USB:SPEed command sets the expected USB signal speed to
be Low Speed (1.5 Mb/s) or Full Speed (12 Mb/s).
Query Syntax
:TRIGger:USB:SPEed?
The :TRIGger:USB:SPEed? query returns the current speed value for the
USB signal.
Return Format
<value><NL>
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":TRIGger:USB:SOURce:DMINus" on page 954
• ":TRIGger:USB:SOURce:DPLus" on page 955
• ":TRIGger:USB:TRIGger" on page 957