To Next Page

To Previous Page

:MEASure Commands 20

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 421

:MEASure:DUAL:VBASe

(see page 1138)

Overview This measurement is available with the N2820A high sensitivity current

probe when both the Primary and Secondary probe cables are used. This

measurement joins the Zoom In waveform data below the probe's clamp

level with Zoom Out waveform data above the probe's clamp level to create

the waveform on which the measurement is made.

Command Syntax

:MEASure:DUAL:VBASe [<source1>][,<source2>]

<source1>,<source2> ::= CHANnel<n> with N2820A probe connected

<n> ::= 1 to (# analog channels) in NR1 format

The :MEASure:DUAL:VBASe command installs a screen measurement and

starts a waveform base value measurement.

If the optional source parameter(s) are specified, the currently specified

source(s) are modified.

Query Syntax

:MEASure:DUAL:VBASe? [<source1>][,<source2>]

The :MEASure:DUAL:VBASe? query returns the vertical value at the base

of the waveform. The base value of a pulse is normally not the same as

the minimum value.

Return Format

<base_voltage><NL>

<base_voltage> ::= value at the base of the selected waveform in

NR3 format

See Also • ":MEASure:DUAL:CHARge" on page 418

• ":MEASure:DUAL:VAMPlitude" on page 419

• ":MEASure:DUAL:VAVerage" on page 420

• ":MEASure:DUAL:VPP" on page 422

• ":MEASure:DUAL:VRMS" on page 423

• "Introduction to :MEASure Commands" on page 406

• ":MEASure:SOURce" on page 444

• ":MEASure:VTOP" on page 465

• ":MEASure:VMIN" on page 460

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series