Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

890 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

31 :TRIGger Commands

:TRIGger:DELay:ARM:SLOPe

(see page 1138)

Command Syntax

:TRIGger:DELay:ARM:SLOPe <slope>

<slope> ::= {NEGative | POSitive}

The :TRIGger:DELay:ARM:SLOPe command specifies rising (POSitive) or

falling (NEGative) for the arming edge in the Edge Then Edge triggger.

Query Syntax

:TRIGger:DELay:ARM:SLOPe?

The :TRIGger:DELay:ARM:SLOPe? query returns the current arming edge

slope setting.

Return Format

<slope> ::= {NEG | POS}

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:DELay:ARM:SOURce" on page 891

• ":TRIGger:DELay:TDELay:TIME" on page 892

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series