Agilent Technologies InfiniiVision 3000 X-Series

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 733
:SBUS<n>:M1553:BASE
(see page 1138)
Command Syntax
:SBUS<n>:M1553:BASE <base>
<base> ::= {BINary | HEX}
The :SBUS<n>:M1553:BASE command determines the base to use for the
MIL- STD- 1553 decode display.
Query Syntax
:SBUS<n>:M1553:BASE?
The :SBUS<n>:M1553:BASE? query returns the current MIL-STD-1553
display decode base.
Return Format
<base><NL>
<base> ::= {BIN | HEX}
Errors • "- 241, Hardware missing" on page 1099
See Also • "Introduction to :SBUS<n> Commands" on page 629
• ":SBUS<n>:M1553 Commands" on page 731