Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:SAVE Commands 26
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 623
:SAVE:WAVeform:LENGth
(see page 1138)
Command Syntax
:SAVE:WAVeform:LENGth <length>
<length> ::= 100 to max. length; an integer in NR1 format
When the :SAVE:WAVeform:LENGth:MAX setting is OFF, the
:SAVE:WAVeform:LENGth command sets the waveform data length (that is,
the number of points saved).
When the :SAVE:WAVeform:LENGth:MAX setting is ON, the
:SAVE:WAVeform:LENGth setting has no effect.
Query Syntax
:SAVE:WAVeform:LENGth?
The :SAVE:WAVeform:LENGth? query returns the current waveform data
length setting.
Return Format
<length><NL>
<length> ::= 100 to max. length; an integer in NR1 format
See Also • "Introduction to :SAVE Commands" on page 607
• ":SAVE:WAVeform:LENGth:MAX" on page 624
• ":SAVE:WAVeform[:STARt]" on page 621
• ":WAVeform:POINts" on page 972
• ":SAVE:WAVeform:FORMat" on page 622

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English