:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 547
:POWer:INRush:APPLy
(see page 1138)
Command Syntax
:POWer:INRush:APPLy
The :POWer:INRush:APPLy command applies the inrush current analysis.
The Inrush current analysis measures the peak inrush current of the
power supply when the power supply is first turned on.
See Also • ":MEASure:PCURrent" on page 483
• ":POWer:INRush:EXIT" on page 548
• ":POWer:INRush:NEXT" on page 549
To Next Page
Loading...
