Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

:TRIGger Commands 31

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 933

:TRIGger:SHOLd:SLOPe

(see page 1138)

Command Syntax

:TRIGger:SHOLd:SLOPe <slope>

<slope> ::= {NEGative | POSitive}

The :TRIGger:SHOLd:SLOPe command specifies whether the rising edge or

the falling edge of the clock signal is used.

Query Syntax

:TRIGger:SHOLd:SLOPe?

The :TRIGger:SHOLd:SLOPe? query returns the current rising or falling

edge setting.

Return Format

<slope> ::= {NEG | POS}

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:MODE" on page 886

• ":TRIGger:SHOLd:SOURce:CLOCk" on page 934

• ":TRIGger:SHOLd:SOURce:DATA" on page 935

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series