Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

912 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

31 :TRIGger Commands

:TRIGger:GLITch:POLarity

(see page 1138)

Command Syntax

:TRIGger:GLITch:POLarity <polarity>

<polarity> ::= {POSitive | NEGative}

The :TRIGger:GLITch:POLarity command sets the polarity for the glitch

pulse width trigger.

Query Syntax

:TRIGger:GLITch:POLarity?

The :TRIGger:GLITch:POLarity? query returns the glitch pulse width trigger

polarity.

Return Format

<polarity> ::= {POS | NEG}

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:MODE" on page 886

• ":TRIGger:GLITch:SOURce" on page 915

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series