Agilent Technologies InfiniiVision 3000 X-Series

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 565
:POWer:SIGNals:CYCLes:HARMonics
(see page 1138)
Command Syntax
:POWer:SIGNals:CYCLes:HARMonics <count>
<count> ::= integer in NR1 format
Legal values are 1 to 100.
The :POWer:SIGNals:CYCLes:HARMonics command specifies the number of
cycles to include in the current harmonics analysis.
Query Syntax
:POWer:SIGNals:CYCLes:HARMonics?
The :POWer:SIGNals:CYCLes:HARMonics query returns the number of
cycles currently set.
Return Format
<count><NL>
<count> ::= integer in NR1 format
See Also • ":POWer:HARMonics:DISPlay" on page 539
• ":POWer:HARMonics:APPLy" on page 537
• ":POWer:SIGNals:AUTosetup" on page 564
• ":POWer:SIGNals:IEXPected" on page 573
• ":POWer:SIGNals:OVERshoot" on page 574
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 581
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 582