840 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
28 :SEARch Commands
:SEARch:SERial:M1553:MODE
(see page 1138)
Command Syntax
:SEARch:SERial:M1553:MODE <value>
<value> ::= {DSTArt | CSTArt | RTA | RTA11 | PERRor | SERRor | MERRor}
The :SEARch:SERial:M1553:MODE command selects the type of
MIL- STD- 1553 information to find in the Lister display:
• DSTArt — searches for the start of a Data word (at the end of a valid
Data Sync pulse).
• CSTArt — searches for the start of a Comamnd/Status word (at the end
of a valid C/S Sync pulse).
• RTA — searches for the Remote Terminal Address (RTA) of a
Command/Status word.
• RTA11 — searches for the Remote Terminal Address (RTA) and the
additional 11 bits of a Command/Status word.
• PERRor — searches for (odd) parity errors for the data in the word.
• SERRor — searches for invalid Sync pulses.
• MERRor — searches for Manchester encoding errors.
In the RTA or RTA11 modes, the Remote Terminal Address is specified
using the :SEARch:SERial:M1553:RTA command.
In the RTA11 mode, the additional 11 bits are specified using the
:SEARch:SERial:M1553:PATTern:DATA command.
Query Syntax
:SEARch:SERial:M1553:MODE?
The :SEARch:SERial:M1553:MODE? query returns the currently selected
mode.
Return Format
<value><NL>
<value> ::= {DSTA | CSTA | RTA | RTA11 | PERR | SERR | MERR}
See Also • Chapter 28, “:SEARch Commands,” starting on page 777
• ":SEARch:SERial:M1553:RTA" on page 842
• ":SEARch:SERial:M1553:PATTern:DATA" on page 841
To Next Page
Loading...
