Agilent Technologies InfiniiVision 3000 X-Series - Hardcopy:grayscale

Obsolete and Discontinued Commands 35
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1063
:HARDcopy:GRAYscale
(see page 1138)
Command Syntax
:HARDcopy:GRAYscale <gray>
<gray> ::= {{OFF | 0} | {ON | 1}}
The :HARDcopy:GRAYscale command controls whether grayscaling is
performed in the hardcopy dump.
Query Syntax
:HARDcopy:GRAYscale?
The :HARDcopy:GRAYscale? query returns a flag indicating whether
grayscaling is performed in the hardcopy dump.
Return Format
<gray><NL>
<gray> ::= {0 | 1}
See Also • "Introduction to :HARDcopy Commands" on page 358
NOTE
The :HARDcopy:GRAYscale command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :HARDcopy:PALette command (see page 371) instead.
(":HARDcopy:GRAYscale ON" is the same as ":HARDcopy:PALette GRAYscale" and
":HARDcopy:GRAYscale OFF" is the same as ":HARDcopy:PALette COLor".)