Agilent Technologies InfiniiVision 3000 X-Series

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 699
:SBUS<n>:I2S:TRIGger:AUDio
(see page 1138)
Command Syntax
:SBUS<n>:I2S:TRIGger:AUDio <audio_ch>
<audio_ch> ::= {RIGHt | LEFT | EITHer}
The :SBUS<n>:I2S:TRIGger:AUDio command specifies the audio channel to
trigger on:
• RIGHt — right channel.
• LEFT— left channel.
• EITHer — right or left channel.
Query Syntax
:SBUS<n>:I2S:TRIGger:AUDio?
The :SBUS<n>:I2S:TRIGger:AUDio? query returns the current audio channel
for the I2S trigger.
Return Format
<audio_ch><NL>
<audio_ch> ::= {RIGH | LEFT | EITH}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:I2S:TRIGger" on page 697