Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Obsolete and Discontinued Commands 35
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1091
:SBUS<n>:LIN:SIGNal:DEFinition
(see page 1138)
Command Syntax
:SBUS<n>:LIN:SIGNal:DEFinition <value>
<value> ::= {LIN | RX | TX}
The :SBUS<n>:LIN:SIGNal:DEFinition command sets the LIN signal type.
These signals can be set to:
Dominant low signals:
• LIN — the actual LIN single- end bus signal line.
• RX — the Receive signal from the LIN bus transceiver.
• TX — the Transmit signal to the LIN bus transceiver.
Query Syntax
:SBUS<n>:LIN:SIGNal:DEFinition?
The :SBUS<n>:LIN:SIGNal:DEFinition? query returns the current LIN signal
type.
Return Format
<value><NL>
<value> ::= LIN
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":SBUS<n>:LIN:SIGNal:BAUDrate" on page 721
• ":SBUS<n>:LIN:SOURce" on page 722
NOTE
This command is available, but the only legal value is LIN.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English