Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

:SBUS<n> Commands 27

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 675

:SBUS<n>:FLEXray:COUNt:RESet

(see page 1138)

Command Syntax

:SBUS<n>:FLEXray:COUNt:RESet

Resets the FlexRay frame counters.

Errors • "- 241, Hardware missing" on page 1099

See Also • ":SBUS<n>:FLEXray:COUNt:NULL" on page 674

• ":SBUS<n>:FLEXray:COUNt:TOTal" on page 677

• ":SBUS<n>:FLEXray:COUNt:SYNC" on page 676

• "Introduction to :SBUS<n> Commands" on page 629

• ":SBUS<n>:MODE" on page 633

• ":SBUS<n>:FLEXray Commands" on page 669

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series