Agilent Technologies InfiniiVision 3000 X-Series

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 757
:SBUS<n>:UART:BASE
(see page 1138)
Command Syntax
:SBUS<n>:UART:BASE <base>
<base> ::= {ASCii | BINary | HEX}
The :SBUS<n>:UART:BASE command determines the base to use for the
UART decode and Lister display.
Query Syntax
:SBUS<n>:UART:BASE?
The :SBUS<n>:UART:BASE? query returns the current UART decode and
Lister base setting.
Return Format
<base><NL>
<base> ::= {ASCii | BINary | HEX}
Errors • "- 241, Hardware missing" on page 1099
See Also • "Introduction to :SBUS<n> Commands" on page 629
• ":SBUS<n>:UART Commands" on page 754