Agilent Technologies InfiniiVision 3000 X-Series

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 593
:POWer:TRANsient:IINitial
(see page 1138)
Command Syntax
:POWer:TRANsient:IINitial <value>[suffix]
<value> ::= Initial current value in NR3 format
[suffix] ::= {A | mA}
The :POWer:TRANsient:IINitial command to specify the initial load current
value. The initial load current will be used as a reference and to trigger
the oscilloscope.
Query Syntax
:POWer:TRANsient:IINitial?
The :POWer:TRANsient:IINitial query returns the initial load current value.
Return Format
<value><NL>
<value> ::= Initial current value in NR3 format
See Also • ":POWer:SIGNals:VSTeady:TRANsient" on page 580
• ":POWer:TRANsient:APPLy" on page 591
• ":POWer:TRANsient:EXIT" on page 592
• ":POWer:TRANsient:INEW" on page 594
• ":POWer:TRANsient:NEXT" on page 595