Agilent Technologies InfiniiVision 3000 X-Series - Mtest:count:reset

:MTESt Commands 22
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 501
:MTESt:COUNt:RESet
(see page 1138)
Command Syntax
:MTESt:COUNt:RESet
The :MTESt:COUNt:RESet command resets the mask statistics.
See Also • "Introduction to :MTESt Commands" on page 491
• ":MTESt:COUNt:WAVeforms" on page 503
• ":MTESt:COUNt:FWAVeforms" on page 500
• ":MTESt:COUNt:TIME" on page 502