656 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:CAN:COUNt:RESet
(see page 1138)
Command Syntax
:SBUS<n>:CAN:COUNt:RESet
Resets the frame counters.
Errors • "- 241, Hardware missing" on page 1099
See Also • ":SBUS<n>:CAN:COUNt:ERRor" on page 654
• ":SBUS<n>:CAN:COUNt:OVERload" on page 655
• ":SBUS<n>:CAN:COUNt:TOTal" on page 657
• ":SBUS<n>:CAN:COUNt:UTILization" on page 658
• "Introduction to :SBUS<n> Commands" on page 629
• ":SBUS<n>:MODE" on page 633
• ":SBUS<n>:CAN Commands" on page 652
To Next Page
Loading...
