Agilent Technologies InfiniiVision 3000 X-Series

1042 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
34 :WMEMory<r> Commands
:WMEMory<r>:YSCale
(see page 1138)
Command Syntax
:WMEMory<r>:YSCale <scale>[<suffix>]
<r> ::= 1-2 in NR1 format
<scale> ::= vertical units per division in NR3 format
<suffix> ::= {V | mV}
The :WMEMory<r>:YSCale command sets the vertical scale, or units per
division, of the selected reference waveform.
Legal values for the scale are copied from the original source waveform
(that is, the analog channel or math function waveform that was originally
saved as a reference waveform).
Query Syntax
:WMEMory<r>:YSCale?
The :WMEMory<r>:YSCale? query returns the current scale setting for the
specified reference waveform.
Return Format
<scale><NL>
<scale> ::= vertical units per division in NR3 format
See Also • Chapter 34, “:WMEMory<r> Commands,” starting on page 1033
• ":WMEMory<r>:DISPlay" on page 1036
• ":WMEMory<r>:YOFFset" on page 1040
• ":WMEMory<r>:YRANge" on page 1041
• ":WMEMory<r>:SKEW" on page 1039