Agilent Technologies InfiniiVision 3000 X-Series

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 741
:SBUS<n>:SPI:CLOCk:SLOPe
(see page 1138)
Command Syntax
:SBUS<n>:SPI:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :SBUS<n>:SPI:CLOCk:SLOPe command specifies the rising edge
(POSitive) or falling edge (NEGative) of the SPI clock source that will
clock in the data.
Query Syntax
:SBUS<n>:SPI:CLOCk:SLOPe?
The :SBUS<n>:SPI:CLOCk:SLOPe? query returns the current SPI clock
source slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:SPI:CLOCk:TIMeout" on page 742
• ":SBUS<n>:SPI:SOURce:CLOCk" on page 744