:SAVE Commands 26
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 617
:SAVE:MULTi[:STARt]
(see page 1138)
Command Syntax
:SAVE:MULTi[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:MULTi[:STARt] command saves multi- channel waveform data to
a file. This file can be opened by the N8900A InfiniiView oscilloscope
analysis software.
See Also • "Introduction to :SAVE Commands" on page 607
• ":SAVE:FILename" on page 609
• ":SAVE:PWD" on page 619
If a file extension is provided as part of a specified <file_name>, it must be ".h5".
To Next Page
Loading...
