:SEARch Commands 28
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 799
:SEARch:TRANsition:SLOPe
(see page 1138)
Command Syntax
:SEARch:TRANsition:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :SEARch:TRANsition:SLOPe command selects whether to search for
rising edge (POSitive slope) transitions or falling edge (NEGative slope)
transitions.
Query Syntax
:SEARch:TRANsition:SLOPe?
The :SEARch:TRANsition:SLOPe? query returns the current transition
search slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • Chapter 28, “:SEARch Commands,” starting on page 777
• ":SEARch:MODE" on page 780
• ":SEARch:TRANsition:SOURce" on page 800
• ":SEARch:TRANsition:TIME" on page 801
To Next Page
Loading...
