Agilent Technologies InfiniiVision 3000 X-Series - Trigger Mode;Coupling

Common (*) Commands 5
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 179
*SAV (Save)
(see page 1138)
Command Syntax
*SAV <value>
<value> ::= {0|1|2|3|4|5|6|7|8|9}
The *SAV command stores the current state of the instrument in a save
register. The data parameter specifies the register where the data will be
saved.
See Also • "Introduction to Common (*) Commands" on page 163
• "*RCL (Recall)" on page 175