Agilent Technologies InfiniiVision 3000 X-Series

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 683
:SBUS<n>:FLEXray:TRIGger:EVENt:TYPE
(see page 1138)
Command Syntax
:SBUS<n>:FLEXray:TRIGger:EVENt:TYPE <event>
<event> ::= {WAKeup | TSS | {FES | DTS} | BSS}
Selects the FlexRay event to trigger on. The event setting is only valid
when the FlexRay trigger mode is set to EVENt.
• WAKeup — triggers on Wake- Up event.
• TSS — triggers on Transmission Start Sequence event.
• FES — triggers on either Frame End or Dynamic Trailing Sequence
event.
• DTS — triggers on either Frame End or Dynamic Trailing Sequence
event.
• BSS — triggers on Byte Start Sequence event.
Query Syntax
:SBUS<n>:FLEXray:TRIGger:EVENt:TYPE?
The :SBUS<n>:FLEXray:TRIGger:EVENt:TYPE? query returns the currently
selected FLEXray event.
Return Format
<event><NL>
<event> ::= {WAK | TSS | {FES | DTS} | BSS}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:FLEXray:TRIGger:EVENt:AUToset" on page 681
• ":SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID" on page 682
• ":SBUS<n>:FLEXray:TRIGger" on page 679
• ":SBUS<n>:FLEXray:AUTosetup" on page 671
• ":SBUS<n>:FLEXray:SOURce" on page 678