Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 571
:POWer:SIGNals:DURation:RIPPle
(see page 1138)
Command Syntax
:POWer:SIGNals:DURation:RIPPle <value>[suffix]
<value> ::= value in NR3 format
[suffix] ::= {s | ms | us | ns}
The :POWer:SIGNals:DURation:RIPPle command specifies the duration of
the output ripple analysis.
Query Syntax
:POWer:SIGNals:DURation:RIPPle?
The :POWer:SIGNals:DURation:RIPPle query returns the set duration time
value.
Return Format
<value><NL>
<value> ::= value in NR3 format
See Also • ":POWer:RIPPle:APPLy" on page 563
• ":POWer:SIGNals:AUTosetup" on page 564
• ":POWer:SIGNals:IEXPected" on page 573
• ":POWer:SIGNals:OVERshoot" on page 574
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 581
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 582

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English