Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

:SBUS<n> Commands 27

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 761

:SBUS<n>:UART:COUNt:RESet

(see page 1138)

Command Syntax

:SBUS<n>:UART:COUNt:RESet

Resets the UART frame counters.

Errors • "- 241, Hardware missing" on page 1099

See Also • ":SBUS<n>:UART:COUNt:ERRor" on page 760

• ":SBUS<n>:UART:COUNt:RXFRames" on page 762

• ":SBUS<n>:UART:COUNt:TXFRames" on page 763

• "Introduction to :SBUS<n> Commands" on page 629

• ":SBUS<n>:MODE" on page 633

• ":SBUS<n>:UART Commands" on page 754

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series