:TRIGger Commands 31
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 955
:TRIGger:USB:SOURce:DPLus
(see page 1138)
Command Syntax
:TRIGger:USB:SOURce:DPLus <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :TRIGger:USB:SOURce:DPLus command sets the source for the USB D+
signal.
Query Syntax
:TRIGger:USB:SOURce:DPLus?
The :TRIGger:USB:SOURce:DPLus? query returns the current source for the
USB D+ signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":TRIGger:USB:SOURce:DMINus" on page 954
• ":TRIGger:USB:TRIGger" on page 957
To Next Page
Loading...
