Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:CALibrate Commands 9
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 257
:CALibrate:STARt
(see page 1138)
Command Syntax
:CALibrate:STARt
The CALibrate:STARt command starts the user calibration procedure.
See Also • "Introduction to :CALibrate Commands" on page 251
• ":CALibrate:PROTected" on page 256
NOTE
Before starting the user calibration procedure, you must set the rear panel CALIBRATION
switch to UNPROTECTED, and you must connect BNC cables from the TRIG OUT connector
to the analog channel inputs. See the User's Guide for details.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English