Agilent Technologies InfiniiVision 3000 X-Series - Power:inrush:exit

548 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:INRush:EXIT
(see page 1138)
Command Syntax
:POWer:INRush:EXIT
The :POWer:INRush:EXIT command exits (stops) the inrush current power
analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope
front panel during the analysis.
See Also • ":POWer:INRush:APPLy" on page 547
• ":POWer:INRush:NEXT" on page 549