Agilent Technologies InfiniiVision 3000 X-Series

:WGEN Commands 33
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1017
:WGEN:MODulation:FSKey:FREQuency
(see page 1138)
Command Syntax
:WGEN:MODulation:FSKey:FREQuency <frequency>
<frequency> ::= hop frequency in Hz in NR3 format
The :WGEN:MODulation:FSKey:FREQuency command specifies the "hop
frequency".
The output frequency "shifts" between the original carrier frequency and
this "hop frequency".
Query Syntax
:WGEN:MODulation:FSKey:FREQuency?
The :WGEN:MODulation:FSKey:FREQuency? query returns the "hop
frequency" setting.
Return Format
<frequency><NL>
<frequency> ::= hop frequency in Hz in NR3 format
See Also • ":WGEN:MODulation:AM:DEPTh" on page 1013
• ":WGEN:MODulation:AM:FREQuency" on page 1014
• ":WGEN:MODulation:FM:DEViation" on page 1015
• ":WGEN:MODulation:FM:FREQuency" on page 1016
• ":WGEN:MODulation:FSKey:RATE" on page 1018
• ":WGEN:MODulation:FUNCtion" on page 1019
• ":WGEN:MODulation:FUNCtion:RAMP:SYMMetry" on page 1020
• ":WGEN:MODulation:STATe" on page 1022
• ":WGEN:MODulation:TYPE" on page 1023