To Next Page

To Previous Page

278 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

10 :CHANnel<n> Commands

:CHANnel<n>:SCALe

(see page 1138)

Command Syntax

:CHANnel<n>:SCALe <scale>[<suffix>]

<scale> ::= vertical units per division in NR3 format

<suffix> ::= {V | mV}

<n> ::= 1 to (# analog channels) in NR1 format

The :CHANnel<n>:SCALe command sets the vertical scale, or units per

division, of the selected channel.

If the probe attenuation is changed, the scale value is multiplied by the

probe's attenuation factor.

Query Syntax

:CHANnel<n>:SCALe?

The :CHANnel<n>:SCALe? query returns the current scale setting for the

specified channel.

Return Format

<scale value> ::= vertical units per division in NR3 format

See Also • "Introduction to :CHANnel<n> Commands" on page 262

• ":CHANnel<n>:RANGe" on page 277

• ":CHANnel<n>:PROBe" on page 271

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series