Agilent Technologies InfiniiVision 3000 X-Series

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 633
:SBUS<n>:MODE
(see page 1138)
Command Syntax
:SBUS<n>:MODE <mode>
<mode> ::= {A429 | FLEXray | CAN | I2S | IIC | LIN | M1553 | SPI | UART}
The :SBUS<n>:MODE command determines the decode mode for the serial
bus.
Query Syntax
:SBUS<n>:MODE?
The :SBUS<n>:MODE? query returns the current serial bus decode mode
setting.
Return Format
<mode><NL>
<mode> ::= {A429 | FLEX | CAN | I2S | IIC | LIN | M1553 | SPI | UART
| NONE}
Errors • "- 241, Hardware missing" on page 1099
See Also • "Introduction to :SBUS<n> Commands" on page 629
• ":SBUS<n>:A429 Commands" on page 634
• ":SBUS<n>:CAN Commands" on page 652
• ":SBUS<n>:FLEXray Commands" on page 669
• ":SBUS<n>:I2S Commands" on page 688
• ":SBUS<n>:IIC Commands" on page 707
• ":SBUS<n>:LIN Commands" on page 717
• ":SBUS<n>:M1553 Commands" on page 731
• ":SBUS<n>:SPI Commands" on page 738
• ":SBUS<n>:UART Commands" on page 754
NOTE
This command is only valid when a serial decode option has been licensed.