:WGEN Commands 33
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1027
:WGEN:PERiod
(see page 1138)
Command Syntax
<period> ::= period in seconds in NR3 format
For all waveforms except Noise and DC, the :WGEN:PERiod command
specifies the period of the waveform.
You can also specify the period indirectly using the :WGEN:FREQuency
command.
Query Syntax
:WGEN:PERiod?
The :WGEN:PERiod? query returns the currently set waveform generator
period.
Return Format
<period><NL>
<period> ::= period in seconds in NR3 format
See Also • "Introduction to :WGEN Commands" on page 998
• ":WGEN:FUNCtion" on page 1007
• ":WGEN:FREQuency" on page 1006
To Next Page
Loading...
