Agilent Technologies InfiniiVision 3000 X-Series

946 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
31 :TRIGger Commands
:TRIGger:TV:POLarity
(see page 1138)
Command Syntax
:TRIGger:TV:POLarity <polarity>
<polarity> ::= {POSitive | NEGative}
The :TRIGger:TV:POLarity command sets the polarity for the TV trigger.
Query Syntax
:TRIGger:TV:POLarity?
The :TRIGger:TV:POLarity? query returns the TV trigger polarity.
Return Format
<polarity><NL>
<polarity> ::= {POS | NEG}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":TRIGger:TV:SOURce" on page 947