Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:SEARch Commands 28
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 809
:SEARch:SERial:CAN:MODE
(see page 1138)
Command Syntax
:SEARch:SERial:CAN:MODE <value>
<value> ::= {DATA | IDData | IDEither | IDRemote | ALLerrors
| OVERload | ERRor}
The :SEARch:SERial:CAN:MODE command selects the type of CAN
information to find in the Lister display:
• DATA - searches for CAN Data frames matching the specified ID, Data,
and the DLC (Data length code).
• IDData - searches for CAN frames matching the specified ID of a Data
frame.
• IDEither - searches for the specified ID, regardless if it is a Remote
frame or a Data frame.
• IDRemote - searches for CAN frames matching the specified ID of a
Remote frame.
• ALLerrors - searches for CAN active error frames and unknown bus
conditions.
• OVERload - searches for CAN overload frames.
• ERRor - searches for CAN Error frame.
Query Syntax
:SEARch:SERial:CAN:MODE?
The :SEARch:SERial:CAN:MODE? query returns the currently selected
mode.
Return Format
<value><NL>
<value> ::= {DATA | IDD | IDE | IDR | ALL | OVER | ERR}
See Also • Chapter 28, “:SEARch Commands,” starting on page 777
• ":SEARch:SERial:CAN:PATTern:DATA" on page 810
• ":SEARch:SERial:CAN:PATTern:ID" on page 812

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English