:TRIGger Commands 31
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 897
:TRIGger:EBURst:COUNt
(see page 1138)
Command Syntax
:TRIGger:EBURst:COUNt <count>
<count> ::= integer in NR1 format
The :TRIGger:EBURst:COUNt command sets the Nth edge at burst counter
resource. The edge counter is used in the trigger stage to determine which
edge in a burst will generate a trigger.
Query Syntax
:TRIGger:EBURst:COUNt?
The :TRIGger:EBURst:COUNt? query returns the current Nth edge of burst
edge counter setting.
Return Format
<count><NL>
<count> ::= integer in NR1 format
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:EBURst:SLOPe" on page 899
• ":TRIGger:EBURst:IDLE" on page 898
To Next Page
Loading...
