Agilent Technologies InfiniiVision 3000 X-Series

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 589
:POWer:SWITch:VCE
(see page 1138)
Command Syntax
:POWer:SWITch:VCE <value>[suffix]
<value> ::= Vce(sat) value in NR3 format
[suffix] ::= {V | mV}
The :POWer:SWITch:VCE command specifies the Vce(sat) value when the
VCE conduction calculation method is chosen (by
:POWer:SWITch:CONDuction).
Query Syntax
:POWer:SWITch:VCE?
The :POWer:SWITch:VCE query returns the Vce(sat) value.
Return Format
<value><NL>
<value> ::= Vce(sat) value in NR3 format
See Also • ":POWer:SWITch:APPLy" on page 585
• ":POWer:SWITch:CONDuction" on page 586
• ":POWer:SWITch:IREFerence" on page 587
• ":POWer:SWITch:RDS" on page 588
• ":POWer:SWITch:VREFerence" on page 590