Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 745
:SBUS<n>:SPI:SOURce:FRAMe
(see page 1138)
Command Syntax
:SBUS<n>:SPI:SOURce:FRAMe <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:SPI:SOURce:FRAMe command sets the frame source when
:SBUS<n>:SPI:FRAMing is set to CHIPselect or NOTChipselect.
Query Syntax
:SBUS<n>:SPI:SOURce:FRAMe?
The :SBUS<n>:SPI:SOURce:FRAMe? query returns the current frame source
for the SPI serial frame.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:SPI:SOURce:CLOCk" on page 744
• ":SBUS<n>:SPI:SOURce:MOSI" on page 747
• ":SBUS<n>:SPI:SOURce:MISO" on page 746
• ":SBUS<n>:SPI:SOURce:DATA" on page 1092
• ":SBUS<n>:SPI:FRAMing" on page 743

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English