To Next Page

To Previous Page

:MEASure Commands 20

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 457

:MEASure:VAVerage

(see page 1138)

Command Syntax

:MEASure:VAVerage [<interval>][,][<source>]

<interval> ::= {CYCLe | DISPlay}

<source> ::= {CHANnel<n> | FUNCtion | MATH | WMEMory<r>}

<n> ::= 1-2 or 1-4 (# of analog channels) in NR1 format

<r> ::= 1-2 in NR1 format

The :MEASure:VAVerage command installs a screen measurement and

starts an average value measurement. If the optional source parameter is

specified, the current source is modified.

The <interval> option lets you specify the measurement interval: either an

integral number of cycles, or the full screen. If <interval> is not specified,

DISPlay is implied.

Query Syntax

:MEASure:VAVerage? [<interval>][,][<source>]

The :MEASure:VAVerage? query returns the average value of an integral

number of periods of the signal. If at least three edges are not present, the

oscilloscope averages all data points.

Return Format

<value> ::= calculated average value in NR3 format

See Also • "Introduction to :MEASure Commands" on page 406

• ":MEASure:SOURce" on page 444

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series