:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 591
:POWer:TRANsient:APPLy
(see page 1138)
Command Syntax
:POWer:TRANsient:APPLy
The :POWer:TRANsient:APPLy command applies the transient analysis
using the initial current and new current settings.
See Also • ":POWer:TRANsient:EXIT" on page 592
• ":POWer:TRANsient:IINitial" on page 593
• ":POWer:TRANsient:INEW" on page 594
• ":POWer:TRANsient:NEXT" on page 595
• ":MEASure:TRESponse" on page 488
To Next Page
Loading...
