Agilent Technologies InfiniiVision 3000 X-Series

:SAVE Commands 26
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 625
:SAVE:WAVeform:SEGMented
(see page 1138)
Command Syntax
:SAVE:WAVeform:SEGMented <option>
<option> ::= {ALL | CURRent}
When segmented memory is used for acquisitions, the
:SAVE:WAVeform:SEGMented command specifies which segments are
included when the waveform is saved:
• ALL — all acquired segments are saved.
• CURRent — only the currently selected segment is saved.
Query Syntax
:SAVE:WAVeform:SEGMented?
The :SAVE:WAVeform:SEGMented? query returns the current segmented
waveform save option setting.
Return Format
<option><NL>
<option> ::= {ALL | CURR}
See Also • "Introduction to :SAVE Commands" on page 607
• ":SAVE:WAVeform[:STARt]" on page 621
• ":SAVE:WAVeform:FORMat" on page 622
• ":SAVE:WAVeform:LENGth" on page 623