Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

986 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

32 :WAVeform Commands

:WAVeform:TYPE

(see page 1138)

Query Syntax

:WAVeform:TYPE?

The :WAVeform:TYPE? query returns the acquisition mode associated with

the currently selected waveform. The acquisition mode is set by the

:ACQuire:TYPE command.

Return Format

<mode> ::= {NORM | PEAK | AVER | HRES}

See Also • "Introduction to :WAVeform Commands" on page 961

• ":ACQuire:TYPE" on page 239

• ":WAVeform:DATA" on page 969

• ":WAVeform:PREamble" on page 976

• ":WAVeform:SOURce" on page 981

NOTE

If the :WAVeform:SOURce is POD1, POD2, or SBUS1, SBUS2, the type is always NORM.

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series