:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 555
:POWer:ONOFf:NEXT
(see page 1138)
Command Syntax
:POWer:ONOFf:NEXT
The :POWer:ONOFf:NEXT command goes to the next step of the turn
on/turn off analysis.
This command is equivalent to pressing the Next softkey on the
oscilloscope front panel when prompted during the analysis.
See Also • ":POWer:ONOFf:APPLy" on page 553
• ":POWer:ONOFf:EXIT" on page 554
• ":POWer:ONOFf:TEST" on page 556
To Next Page
Loading...
