Agilent Technologies InfiniiVision 3000 X-Series

:MTESt Commands 22
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 511
:MTESt:RMODe:FACTion:SAVE
(see page 1138)
Command Syntax
:MTESt:RMODe:FACTion:SAVE <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}}
The :MTESt:RMODe:FACTion:SAVE command sets saving on mask failures
on or off.
See Chapter 26, “:SAVE Commands,” starting on page 605 for more
information on save options.
Query Syntax
:MTESt:RMODe:FACTion:SAVE?
The :MTESt:RMODe:FACTion:SAVE? query returns the current mask failure
save setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :MTESt Commands" on page 491
• ":MTESt:RMODe:FACTion:MEASure" on page 509
• ":MTESt:RMODe:FACTion:PRINt" on page 510
• ":MTESt:RMODe:FACTion:STOP" on page 512
NOTE
Setting :MTESt:RMODe:FACTion:SAVE ON automatically sets
:MTESt:RMODe:FACTion:PRINt OFF.